Thingiverse
filament guide
von ldelana77
19
Downloads
7
Likes
0
Makes
Filament guide for **EZT T1 Delta 3D Printer** fixed with M5 T Type Nut and M5 Grub Screw.
Allow application without ejection of filament due to the gap of 0.4mm enough to insert a 1.75mm filament by bending a little and to make at the same time difficult exiting during printing.
Internals of the filament guide are smoothed using fillet for a better scrolling.
Parts thickness : 2.8mm
2018-09-23 : updated version with reinforcements
Allow application without ejection of filament due to the gap of 0.4mm enough to insert a 1.75mm filament by bending a little and to make at the same time difficult exiting during printing.
Internals of the filament guide are smoothed using fillet for a better scrolling.
Parts thickness : 2.8mm
2018-09-23 : updated version with reinforcements
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
