Thingiverse
filament guide
door PrintMeSome
4
Downloads
1
Likes
0
Makes
I printed this for my Neptune 2S
this print needs supports
I used lines and it came out great
print on a raft for best results.
the roller requires 2 standard 608 bearings.
the two circles depending on how close your printers detail is, may or may not need superglue. I have printed 4 and only 1 needed superglue other then that it press fit just fine.
the slower the better for this print.
I made the pin so it would take a standard cotter pin 1.38 x 28. just a small pace of wire would hold it.
this print needs supports
I used lines and it came out great
print on a raft for best results.
the roller requires 2 standard 608 bearings.
the two circles depending on how close your printers detail is, may or may not need superglue. I have printed 4 and only 1 needed superglue other then that it press fit just fine.
the slower the better for this print.
I made the pin so it would take a standard cotter pin 1.38 x 28. just a small pace of wire would hold it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!