Thingiverse
Filament Guide
von FireGodSpeed
0
Downloads
0
Likes
0
Makes
Easy to print filament guide, use supports touching baseplate for the filament side.
I used a M4x12mm screw, instead of the m4x6 that was installed before.
(The Hole for the screw is 5mm in Diameter (screw =m4). I used a m4x12mm)
I used a M4x12mm screw, instead of the m4x6 that was installed before.
(The Hole for the screw is 5mm in Diameter (screw =m4). I used a m4x12mm)
FireGodSpeed veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!