Thingiverse
Filament Holder Track
por Ghost_Rider
3
Descargas
2
Likes
0
Makes
These files are for a homemade filament drybox
For a 4ft box that holds 14 rolls you will need:
-Base end (1)
-Base (3)
-Bearing holder (56)
-Bearing (56)
-DryBox Handle (2)
-Part_holder (28)
The only parts that will need supports are the Part holders (Under the 90 degree over hangs), and the handles (under the large 90 degree overhang). Everything else is flat on the bed with absolutely no bridging. The angle under the Bases are roughly 50 degrees so use supports if needed. The Base end is shorter than the Base as it gives enough room for removing the filament holders after assembly
For a 4ft box that holds 14 rolls you will need:
-Base end (1)
-Base (3)
-Bearing holder (56)
-Bearing (56)
-DryBox Handle (2)
-Part_holder (28)
The only parts that will need supports are the Part holders (Under the 90 degree over hangs), and the handles (under the large 90 degree overhang). Everything else is flat on the bed with absolutely no bridging. The angle under the Bases are roughly 50 degrees so use supports if needed. The Base end is shorter than the Base as it gives enough room for removing the filament holders after assembly
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
