Filament Holder

Filament spool holder that uses bearings to reduce resistance.

Print 4 of the filament holders.
Purchase the list of hardware below.
Bolt the two sets of the prints together in the following order:

Bolt - Filament Holder - flat washer - bearing - flat washer - filament holder - lock nut.

Do not over tighten lock nut.

Material List:
Metric
6mm bore X 13mmOD Bearing - 2X
M6-1.0 X 20mm Zinc Screw - 2X
M6-1.0 Zinc Hex nut - 2X
M6 x 12mm Flat Washer - 4X

Standard
1/4in X 3/4in Bolt - 2X
1/4in Lock nut - 2X
1/4in Flat Washer - 4X
1/4in bore x 1/2inOD Miniature Bearing - 2X