Thingiverse
Filament Holder
par GeneralBonkers
7
Téléchargements
4
Likes
0
Makes
My first useful design using TinkerCad.
I used a raft for bed adhesion and to make it easier to remove after printing.
I designed it to fit using the same screws used for the filament spooler on the Ender 3 Pro.
(I attached a file for you to print if you want to test if the screws fit for you.)
Printed at .2mm layer height but I'm sure you can go higher for a faster print time.
Infill is 20 percent density with zigzag design.
I used a raft for bed adhesion and to make it easier to remove after printing.
I designed it to fit using the same screws used for the filament spooler on the Ender 3 Pro.
(I attached a file for you to print if you want to test if the screws fit for you.)
Printed at .2mm layer height but I'm sure you can go higher for a faster print time.
Infill is 20 percent density with zigzag design.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
