Thingiverse
filament holder
by el_tuba
6
Downloads
2
Likes
0
Makes
This is a cone with a bearing inside to hold the filament.
The diameter of the coil is 40mm and the bearing is a 608zz the same bearing we use in the extruder. I use it with a M8 nut and a washer in both sides.
You need to print 2 cones
It's very simple but effective!
The diameter of the coil is 40mm and the bearing is a 608zz the same bearing we use in the extruder. I use it with a M8 nut and a washer in both sides.
You need to print 2 cones
It's very simple but effective!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
