Slicer Discord
Filament + jam Sensor  – Modèle 3D imprimable de Thingiverse Thingiverse

Filament + jam Sensor

175 Téléchargements
91 Likes
1 Makes
Voir le modèle
UPDATE:
Hello guys! I have my first Kickstarter project running! Please check it out and share this link!
https://www.kickstarter.com/projects/kenzoselleslaghs/rgb-touchpanel-for-micro-controller-s

Many thanks!


Hello guys
As promised
I did a remake of my old filament sensor because there were to many parts, and it was heavy.

So this sensor detects jams in the hotend also running out of filament.
It uses a sensor and an arduino

How does it work?

- filaments spins the toothed wheel in the sensor, the sensor goes high to low and vice versa. The arduino calculates if the time between HIGH and LOW is between the programmed time, if not the arduino pin will go high and sends a signal to your buzzer
(more info in the arduino sketch)


Use dark plastic for the toothed filament roller, i noticed if you use light plastic the sensor readings where not reliable, so i covered the tooth with paint...
if the filament slips use double sided tape in the toothed roller, i
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Peinture, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection