Thingiverse
Filament Joiner
door Paul020559
139
Downloads
101
Likes
1
Makes
New design. Weld the knurled knobs onto 4mm screw/bolt. Snap square nuts into the bottom part - superglue them in. I used a couple of 14mm bolts that came as extras with my Prusa Mk3s.
Screw the filament ends tight and hold the gap over a tealight or candle flame. Squish the ends together until cool (or hold the device legs together with clothes peg or similar). Open the device arms and trim the squashed bulge - sand smooth.
If you found this useful, please donate what you think it is worth to paypal.me.
Help cover the time of design.
Thanks, Enjoy!
Screw the filament ends tight and hold the gap over a tealight or candle flame. Squish the ends together until cool (or hold the device legs together with clothes peg or similar). Open the device arms and trim the squashed bulge - sand smooth.
If you found this useful, please donate what you think it is worth to paypal.me.
Help cover the time of design.
Thanks, Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
