Filament Rack

FILAMENT STORAGE!!It's all something that we have a tough time with, and this is my take on an efficiant storage system for your spools!!MaterialsAll you need is the printed part, plate one, two 12mm rods or tubes, any length will work (here is the amazon link to the ones I used), some drywall skrews (You may not need any if you have two studs where you want to put the rack) and some generic skrews, and a drill. There are no pre-printed skrew holes, so you have to drill through it. Use the drill bit that fitst your skrews you are using. Then you just need some filament spools to store.DirectionsPrint the sizing ring for the tube. Usually you will need to scale the part anywere from 0.4% to 0.9% to fit the skrinkage rate of any filaments. The sizing ring is allready scaled 100.04%. You may need to print the part a few times, scaling it up and down a in between prints. The rod should fit with just a little bit of wiggle room, just enough to rool around.After printing and sizing the r