Thingiverse
Filament rack
por Artybaba
0
Descargas
0
Likes
0
Makes
I needed a filament rack and and didn't like the existing designs, so I ended up designing one. You can load up to 4 of the 1Kg filaments with no issues.
I printed these parts using an Elegoo Carbon Century and good old PLA filament.
I used the original slicer settings and the only change was to the fill density from 15 to 100%.
in the slicer, You are gonna have to mirror the wall mount to print the other side of it. Make sure you lay it flat and you can print both mounts at the same time.
For the pole, lay it diagonally and lay it on its flat side for smoothness and max strength. print the pole separately. enjoy printing and if you have any feedbacks let me know, greatly appreciated.
I printed these parts using an Elegoo Carbon Century and good old PLA filament.
I used the original slicer settings and the only change was to the fill density from 15 to 100%.
in the slicer, You are gonna have to mirror the wall mount to print the other side of it. Make sure you lay it flat and you can print both mounts at the same time.
For the pole, lay it diagonally and lay it on its flat side for smoothness and max strength. print the pole separately. enjoy printing and if you have any feedbacks let me know, greatly appreciated.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
