Thingiverse
Filament Reel Roll
by porter7o
6
Downloads
5
Likes
0
Makes
This is a tapered filament reel insert that should fit 3 different sizes from 2.25 in (57.15mm) to 2.34 in (59.4mm) reel holes. I've included the Inventor part if you want to change a few dimensions for your specific rolls.
The inside hole is 0.75 in (19mm) and was plenty big to get any nuts on my reel rod through without any issues. I added tape to my rod so it doesn't wear the plastic out.
I recommend using 1 or 2 mm wall thickness and 20-25% fill. You want it to be a little flexible so it pops in the roll and stays in. The rounded curves should help it stay in!
The inside hole is 0.75 in (19mm) and was plenty big to get any nuts on my reel rod through without any issues. I added tape to my rod so it doesn't wear the plastic out.
I recommend using 1 or 2 mm wall thickness and 20-25% fill. You want it to be a little flexible so it pops in the roll and stays in. The rounded curves should help it stay in!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!