FIlament Roll Stop / Storage

Hey! This is a simple solution I came up with to store Filament rolls inside a normal closet the easy way :) Its a fast Print, with low filament usage and the assembly is easy! I designed it around a 20mm Diameter wooden rod. Its scalable for your preferences! You dont need to change the Print, just the length of the rod youre using is the key :) I have plans to expand the system in the future! Tell me your Ideas! Now have a nice print and an amazing day! Assembly: Print the amount of holders you need with your preferred settings (I advise to use 0.28 Layer height for a fast print). Youll need at least two of them. If you plan a longer version then mine (mine is around 70cm long) I advise you to print at least one more (so three) for the middle to prevent sagging Cut the 20mm diameter rod to your preferred lenght. The holes have low tolerences so I would advise you to use wood so you can sand it down if needed. Now you just need to pressfit the rods into the holders. Done! c: I hope yo