Filament Runout Sensor Mounting bracket

This is a snap-fit mount I created for the 'Ender Filament Runout Sensor' by ryroo211 https://www.thingiverse.com/thing:4073699

I have added two sunken areas to install doubleheader-tape if for some reason it does not snap in place for you although I have had no issues.

Using one hole for the mounting screw allows you to angle (rotate) the filament run-out sensor in whichever way fits you best

I printed this adapter using 0.1 Layer hight with 100% Infill and same settings with royroo211's Filament runout sensor using PLA

I recommend using a M4x12 screw with a M4 nut and T-Nut adapter like the one from KenNox at http://www.thingiverse.com/thing:3313417