Thingiverse
Filament Runout Sensor
von Low_Frequency
9
Downloads
3
Likes
0
Makes
I recently did t dual z-axis with z braces upgradeby proper printing (https://www.thingiverse.com/thing:3719799) and wanted to use a filament runout sensor
Since almost every sensor is mounted to the extruder and would limit the movement in z I decided to design my own and mount it out of the way on the z brace
I bought endstops from amazon (shorturl.at/loJP4) and designed the case around it
Additional hardware used:
4x M3x10
4x M3x12
8x M3 Nuts
Some Wire
Solder
Dupont Connectors
Shrink Wrap
PTFE Tubing
Since almost every sensor is mounted to the extruder and would limit the movement in z I decided to design my own and mount it out of the way on the z brace
I bought endstops from amazon (shorturl.at/loJP4) and designed the case around it
Additional hardware used:
4x M3x10
4x M3x12
8x M3 Nuts
Some Wire
Solder
Dupont Connectors
Shrink Wrap
PTFE Tubing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
