Thingiverse
Filament Runout Sensor
von Ptorres2020
3
Downloads
1
Likes
0
Makes
An enclosure for a small end switch to use as a filament sensor.
I Design to fix in the support plate of an Hypercube Evolution, but it can be easily change to fix in others setups.
If you only want the enclosure, print the Sensor B + Sensor B (Mirror).
To assembly, i use a spare filament (1,75mm diameter) to fix the Sensor in the enclosure (holes) and 2 M3x10 screws + 2 Brass plastic Inserts.
I Design to fix in the support plate of an Hypercube Evolution, but it can be easily change to fix in others setups.
If you only want the enclosure, print the Sensor B + Sensor B (Mirror).
To assembly, i use a spare filament (1,75mm diameter) to fix the Sensor in the enclosure (holes) and 2 M3x10 screws + 2 Brass plastic Inserts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
