Filament Sensor Guide

**Update 25-08: After using this for a while, i learned using a filament sensor as shown in the photo is NOT a good idea, the curve of the filament is to sharp and might break. I checked the "work-in-progress" with this thing since I do plan to remix it to support my type of sensor in a better way.**

Not that much of a remix, but the thing I based this on contained other objects I did not want in the STL.
Since I couldn't "ungroup" and discard those in my slicer I used Tinkercad to remove it, which was quite some hassle.

Also it was not designed for my Filament sensor per se, but I attached a photo how I still made it work.

You need a M3x25 and a M3 hex nut as well (actually two if you have a fitting filament sensor).