Thingiverse
Filament Sensor Holder
von TheTrolli
5
Downloads
4
Likes
0
Makes
This is a more ridgit filament sensor holder for the Anycubic Vyper.
There are 2 versions.
The one without the gap it a simple replacement for the stock holder.
The second one has a gap in the back part that allows you to add the Vyper Hotend Cable Holder (https://www.thingiverse.com/thing:4939641).
The sensor holder also has a hole so you can add a 16 mm long m3 screw wit a nut to secure the sensor even more.
The holder only needs support on the bottom gaps for the screw holes. The top part that goes around the sensor exit doesnt need any support.
There are 2 versions.
The one without the gap it a simple replacement for the stock holder.
The second one has a gap in the back part that allows you to add the Vyper Hotend Cable Holder (https://www.thingiverse.com/thing:4939641).
The sensor holder also has a hole so you can add a 16 mm long m3 screw wit a nut to secure the sensor even more.
The holder only needs support on the bottom gaps for the screw holes. The top part that goes around the sensor exit doesnt need any support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
