Thingiverse
Filament Sensor Housing
por finchmeister08
2
Descargas
3
Likes
0
Makes
Created for an Ender 3 v2. It might work on other models, but I don't know about which ones are similar so download on your own risk. Below is an Amazon link on the specific sensor I bought:
https://www.amazon.com/dp/B08QJDSZCL?psc=1&ref=ppx_yo2_dt_b_product_details
You might need to reconfigure your firmware. Apparently, the switches have two positions:
HIGH
LOW
Jyers firmware is default to LOW. This caused the switch to work opposite as it was intended. It would pause prints with filament in the sensor and run while it was empty. Just change FIL_RUNOUT_STATE to HIGH or opposite of whatever your setting is if you have the same issue as me and retest.
https://www.amazon.com/dp/B08QJDSZCL?psc=1&ref=ppx_yo2_dt_b_product_details
You might need to reconfigure your firmware. Apparently, the switches have two positions:
HIGH
LOW
Jyers firmware is default to LOW. This caused the switch to work opposite as it was intended. It would pause prints with filament in the sensor and run while it was empty. Just change FIL_RUNOUT_STATE to HIGH or opposite of whatever your setting is if you have the same issue as me and retest.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
