Thingiverse
FILAMENT SENSOR MOUNT - REMIXED
von techguychad
19
Downloads
10
Likes
0
Makes
This Filament runout sensor mount is based on the impressive "Filament Sensor Mount" by Jarod_can_make_it
https://www.thingiverse.com/thing:4639874
I remixed it and made some changes to the screw hole and made them all 3mm. I also squared off the edges and made small adjustments to the overall size. Plus add a T for Tenlog but also included it without the T.
To connect the sensor to the mount I used M3x30mm Head cap Screws.
To attach the sensor to the cable I used M3x20mm Flat Head Cap Screws.
https://www.thingiverse.com/thing:4639874
I remixed it and made some changes to the screw hole and made them all 3mm. I also squared off the edges and made small adjustments to the overall size. Plus add a T for Tenlog but also included it without the T.
To connect the sensor to the mount I used M3x30mm Head cap Screws.
To attach the sensor to the cable I used M3x20mm Flat Head Cap Screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
