Thingiverse
Filament Sensor Mount
von dtrigger
1
Downloads
1
Likes
0
Makes
This project is for the Creality CR-10 V3 where the filament sensor is mounted on the top horizontal bar next to the filament roll.
I got sick and tired of the filament sensor wire banging into things as I was printing, so I decided to move the sensor. By placing the sensor above the Titan Extruder, the sensor wire can be threaded through the braided wire sleeve.
A nice bonus is that if you're using a CR/BL Touch bed levelling sensor, you can wrap the wire behind the filament sensor mount to help project it from the extruder wheel.
In addition to the printed parts, you will need 4 M3 hex nuts, and 4 M3x22mm flat head screws.
I got sick and tired of the filament sensor wire banging into things as I was printing, so I decided to move the sensor. By placing the sensor above the Titan Extruder, the sensor wire can be threaded through the braided wire sleeve.
A nice bonus is that if you're using a CR/BL Touch bed levelling sensor, you can wrap the wire behind the filament sensor mount to help project it from the extruder wheel.
In addition to the printed parts, you will need 4 M3 hex nuts, and 4 M3x22mm flat head screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
