Filament Sensor Spool mount

This is a work in progress. It is a re-mix using Peter Solomon's sensor, of course modified for this application. The screw holes are still there, but you will not need them as I have crudely made the two halves snap together. This thing mounts directly to your filament spool at the holder (CR-10(s) and other Creality printers and is specifically made for those spool holders. It could be modified however to work with virtually any printer which can incorporate a filament out sensor.

Parts needed. You will need to print two Spool Control Arms, and one each of the mount and Cap. You will also need two small screws and 90mm of bowden tube. 10mm of the bowden tube is to be used in the sensor inlet guide hole and the other 80mm is used to attach the sensor case to the control arms. *0mm is needed for separation to allow the sensor case to "free float" while being held to the spool. The filament is free to flow out of the spool and into the printer without drag, and there is no concern th