Thingiverse
Filament Sensor Tevo Tornado
von dvilleneuve
304
Downloads
149
Likes
1
Makes
This is a filament sensor for the tevo tornado.
Print it, put a KW12-3 PCB switch on it, screw it on the X axis screw (on the extra part of the bolt), connect the cable to Z+, change the FW and you're good to go !
configuration.h
\#define FILAMENT_RUNOUT_SENSOR
configuration_adv.h
\#if ENABLED(ULTIPANEL)
\#define ADVANCED_PAUSE_FEATURE
\#define FILAMENT_CHANGE_UNLOAD_LENGTH 0
\#define FILAMENT_CHANGE_LOAD_LENGTH 0
\#define ADVANCED_PAUSE_EXTRUDE_LENGTH 0
pins_RAPMS.h
//\#define Z_MAX_PIN 19
\#define FIL_RUNOUT_PIN 19
Print it, put a KW12-3 PCB switch on it, screw it on the X axis screw (on the extra part of the bolt), connect the cable to Z+, change the FW and you're good to go !
configuration.h
\#define FILAMENT_RUNOUT_SENSOR
configuration_adv.h
\#if ENABLED(ULTIPANEL)
\#define ADVANCED_PAUSE_FEATURE
\#define FILAMENT_CHANGE_UNLOAD_LENGTH 0
\#define FILAMENT_CHANGE_LOAD_LENGTH 0
\#define ADVANCED_PAUSE_EXTRUDE_LENGTH 0
pins_RAPMS.h
//\#define Z_MAX_PIN 19
\#define FIL_RUNOUT_PIN 19
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
