Thingiverse
Filament Shelf Modular System
door FilamentKing
6
Downloads
7
Likes
0
Makes
How to Build Filament Shelves:
This is a modular system that interlocks rows of stabilizers with rows of shelves.
If you are only going to have a single column of shelves, then you will not need any stabilizers
Rows of stabilizers start with a half panel and end with a half panel. These two half panels count a one full panel.
In this example we will demonstrate how to construct a bank that is three columns wide.
Do not use supports when printing. Specialty supports are designed into the models (a nod to Rick and Morty).
Bambu Lab users should have presets of: No Brim, No Supports, Sparse Infill Density 5%, Wall Loops 2, Top Shell Layers 5, Bottom Shell Layers 3. These settings will save filament and reduce print times while keeping them strong.
Start by printing two half and two full stabilizer panels with cutouts
Assemble the panels on the surface you plan to build your shelves.
Note: One side is convex, and the other side is concave. Some accessories require the convex side
This is a modular system that interlocks rows of stabilizers with rows of shelves.
If you are only going to have a single column of shelves, then you will not need any stabilizers
Rows of stabilizers start with a half panel and end with a half panel. These two half panels count a one full panel.
In this example we will demonstrate how to construct a bank that is three columns wide.
Do not use supports when printing. Specialty supports are designed into the models (a nod to Rick and Morty).
Bambu Lab users should have presets of: No Brim, No Supports, Sparse Infill Density 5%, Wall Loops 2, Top Shell Layers 5, Bottom Shell Layers 3. These settings will save filament and reduce print times while keeping them strong.
Start by printing two half and two full stabilizer panels with cutouts
Assemble the panels on the surface you plan to build your shelves.
Note: One side is convex, and the other side is concave. Some accessories require the convex side
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
