Thingiverse
Filament_Spool_5th_replicator
door zimhe
5
Downloads
1
Likes
0
Makes
a spool design that does not take any extra space outside the machine
structured on the front-left pillar of the machine, pull the pillar with the upper arm, push with the lower arm, fixing the center point.
it does not take any extra space outside the machine, make some useless space inside it useful.
hope u like it.
p.s.: the arms are a little loose holding the pillar, because I gave 1mm space between the pillar and the arm, in case any incorrect measure
structured on the front-left pillar of the machine, pull the pillar with the upper arm, push with the lower arm, fixing the center point.
it does not take any extra space outside the machine, make some useless space inside it useful.
hope u like it.
p.s.: the arms are a little loose holding the pillar, because I gave 1mm space between the pillar and the arm, in case any incorrect measure
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!