Filament Spool Holder for Multiboard

Filament spool holder for Multiboard Based on the design by 3D art and remixed by StarBuck Starbuck's design for multiboard was nice and printed great however the weight of the spools would pull the snap connectors out (which I may have used in a way that was not intended) so I printed Andre P's screw in mounts to push fit the spool holder into, the issue with that was I had a lot of trouble pushing the spool holder into the screw in connectors which resulted in misaligned spool holder when mounted in a long line, my OCD couldn't take it so I pulled the male connectors off of Starbuck's design and attached slide connectors, now you just screw in the slide connectors and slide the spool holder onto those and they all line up the same with the same strength as what I had previously tried. Supports are needed.Thanks to StarBuck for the idea, thanks to 3D art for the original, and thanks to David D for his slide connectors Boost MeAll boosts are greatly appreciated and go d