Filament Spool Holder

This model is a filament spool holder that I made when using Fusion 360 for the first time !! My goal for this model was to have a sturdy, waste cautious part that can be easily mounted to wall studs; given long enough screws are used. The part has built in tolerances for any pipe or rod that is 19 or 20 mm (0.748 or 0.787 in) in diameter. The spool holder was build for spool rolls that have a diameter of 20 cm (7.87 in), but anything with a diameter within the range of 14-25 cm can be supported without modification. Extremely minimal supports required; if enabled, the only supports required are located around the screw holes. ⚠ Note:The 3D print has not been vigorously tested, and may fail under loads upwards of 30 kgThe model has only been tested for ≈15-20 kg, and been tested in PETG using current model settings.The model is not supported on A1 Mini printers, as the base plate is too small.The model has an optional second plate if 19 mm pipe is used. To use the end caps, simply plac