Filament Spool Holder

I designed this holder to work with most any Filament Spool. You will need 4 standard skateboard wheel bearings. I hope it is obvious where to install them. I have included holes in the Base for an all-thread to hold them together; if that becomes an issue for you.
You will need to print 2 of each.
Print the Base separate from the Rollers.
Use support on the Base, but not on the Rollers.
Though they look like they need it; I designed the Rollers to not need support (It was a bitch to remove.) to get a print.
Try to print them in the same orientation you receive them.
My design has worked with broken spools.
Good luck
Feel free to let me know what you think.