Filament Spool Holder

Just another filament spool holder. If your filament's spool has a large hole, you can skip printing SpoolHolder3Shaft and use a short length of 1/2" or 3/4" PVC pipe.

Print 1 each SpoolHolder3Left and SpoolHolder3Right, and 2 each of SpoolHolder3CrossBrace Optionally, print 1 SpoolHolder3Shaft.

Assembly is pretty obvious.

You should notice that the V for the shaft is offset from the center of the sides and that one side of the V is more vertical than the other. The more vertical side of the V should be toward your printer to reduce the possibility of the spool being pulled off of the fixture.