Filament Spool Holder

Filament Spool Holder
====================
A simple filament spool holder which can be printed in one part on most 3D printers.

Note
---------------------
The original version could be printet with 10 infill, i am unsure if this remix will work with 10 infill.
The new remix is made with Sketchup and only the size (width / height ) is the same.

New in this remix:
---------------------
* Making the base wider, making it more stable.
* Making the back wider, making it more stable.
* Making a hole / gap in the middle on the holder, making it have a less volume (lower printing cost). (vol:0.18 cm3 without the gap - vol:0.17 cm3 with gap)
* Made it "water / air tight". Making it useable for print houses to calculate cost without having to fix holes / gaps etc in the stl.
* Made the stop part (to avoid the spool from falling of) a full polygon instead of half polygon (simply didnt like the look)
* Removing a ton of lines that had no purpose ( just to make it more clean loo