Thingiverse
Filament Spool Holder
von 3DStartups
5.6k
Downloads
4.9k
Likes
21
Makes
This is a filament spool holder specifically designed for E-Sun 3D filament!
2x Arms
2x Hooks
Print the four pieces horizontally and snap the two arms into one of the hooks. Place the filament and then attach the additional hook.
The filament can then be fed through the two arms located on the arm bar and effectively sinch the filament into place. This allows you to hang the filament on a coat hanger without it spinning and spooling out.
2x Arms
2x Hooks
Print the four pieces horizontally and snap the two arms into one of the hooks. Place the filament and then attach the additional hook.
The filament can then be fed through the two arms located on the arm bar and effectively sinch the filament into place. This allows you to hang the filament on a coat hanger without it spinning and spooling out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
