Thingiverse
Filament Spool Holder
door Nerotrashminter
19
Downloads
18
Likes
1
Makes
This is a very simple filament spool holder design for spools that are ~20cm in diameter and ~7cm in width.
All pieces were printed in PLA with 20 percent infill. I printed the spool holder cylinder horizontally to reduce support material. The main body does not require any support material.
The main body should be printed with the flat (bottom) side down. (I could not get Thingiverse to orient the model correctly.)
All pieces were printed in PLA with 20 percent infill. I printed the spool holder cylinder horizontally to reduce support material. The main body does not require any support material.
The main body should be printed with the flat (bottom) side down. (I could not get Thingiverse to orient the model correctly.)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
