Thingiverse
Filament spool holder
door EVXAB
5
Downloads
2
Likes
0
Makes
English
EVXAB.COM® "Filament spool holder" fits filament rolls up to 90 mm. The ball bearing rollers helps the filament to unroll without resistance. The filament roll can move to the right and left during use but is supported by side pieces so it cannot tip over or fall off.
The supplied thin tube is optional but recommended to get a free movement of the filament spool. Small defects in the printed pipe can otherwise cause occasional locking.
Note:
EVX_Spool_Holder_Skin.stl should be printed in vase mode.
Accessories needed to complete the build:
4 pcs ball bearing (ABEC7, 608ZZ)
4 pcs M3 square nut
4 pcs M3 screw (Torx T10)
4 pcs rubber feet
Accessories kit:
https://q.evxab.com/DCX1
In a hurry? Buy a ready to use version:
https://q.evxab.com/jMSE
Swedish
EVXAB.COM® "Hållare för filamentrulle" passar filamentrullar upp till 90 mm. De lagerupphängda rullarna medför avrullning av filamentet utan motstånd. Filamentrullen kan röra sig till höger och vänste
EVXAB.COM® "Filament spool holder" fits filament rolls up to 90 mm. The ball bearing rollers helps the filament to unroll without resistance. The filament roll can move to the right and left during use but is supported by side pieces so it cannot tip over or fall off.
The supplied thin tube is optional but recommended to get a free movement of the filament spool. Small defects in the printed pipe can otherwise cause occasional locking.
Note:
EVX_Spool_Holder_Skin.stl should be printed in vase mode.
Accessories needed to complete the build:
4 pcs ball bearing (ABEC7, 608ZZ)
4 pcs M3 square nut
4 pcs M3 screw (Torx T10)
4 pcs rubber feet
Accessories kit:
https://q.evxab.com/DCX1
In a hurry? Buy a ready to use version:
https://q.evxab.com/jMSE
Swedish
EVXAB.COM® "Hållare för filamentrulle" passar filamentrullar upp till 90 mm. De lagerupphängda rullarna medför avrullning av filamentet utan motstånd. Filamentrullen kan röra sig till höger och vänste
EVXAB publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
