Thingiverse
Filament Spool Holder
von Oriode
9
Downloads
4
Likes
0
Makes
I designed this spool holder to replace the original one on my Creality CR-10S.
It can be attached directly on the CR-10 by replacing the original one.
You will need :
- x4 "608" bearings (skateboard/handspinner bearings)
- x4 16mm M3 screws
- x1 20mm M3 screw
- x5 M3 nuts
Print the Wheel and the Wheel.Inside parts in TPU or any flex material with 100% infill.
Others parts can be printed in PLA.
It can be attached directly on the CR-10 by replacing the original one.
You will need :
- x4 "608" bearings (skateboard/handspinner bearings)
- x4 16mm M3 screws
- x1 20mm M3 screw
- x5 M3 nuts
Print the Wheel and the Wheel.Inside parts in TPU or any flex material with 100% infill.
Others parts can be printed in PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
