Thingiverse
Filament Spool Holder
von Plastic_Diamond
2
Downloads
0
Likes
0
Makes
Made a filament spool, pretty simple to print since its just one part
I would recommend using tree branch supports and a layer height of 0.28mm
I would also say to scale it up in your slicer by maybe 5 or 10 percent to make sure it comfortably fits your spools.
I used a wall count of 3 and cubic infill (10%) and it printed very fast and easy
I would recommend using tree branch supports and a layer height of 0.28mm
I would also say to scale it up in your slicer by maybe 5 or 10 percent to make sure it comfortably fits your spools.
I used a wall count of 3 and cubic infill (10%) and it printed very fast and easy
Plastic_Diamond veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
