Thingiverse
Filament Spool Holder with Dustfilter
door Matze-x2
13
Downloads
14
Likes
0
Makes
A simple filament-spool-holder with a dustfilter.
It's especially for a "BQ-Filament"-spool, but you can use this for any Spool with a width of 73,5mm.
Use a ball bearing with an 8mm center diameter, just like a normal skateboard-ball bearing.
and M3x25 countersunk screws.
I glued the the two things between the Inside.
I apologize for my bad english...
greetings!
It's especially for a "BQ-Filament"-spool, but you can use this for any Spool with a width of 73,5mm.
Use a ball bearing with an 8mm center diameter, just like a normal skateboard-ball bearing.
and M3x25 countersunk screws.
I glued the the two things between the Inside.
I apologize for my bad english...
greetings!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
