Thingiverse
Filament spool holding frames
door LukeB1234
2
Downloads
2
Likes
0
Makes
**Print on side as pictured**
I printed on my CR10S-PRO and it worked a treat, Not sure whether it would work as well if scaled down though.
2 x lengths of 16mm tube are required and can be bought in most DIY stores or on eBay.
The holes in the frames were designed to allow a tie wraps or Velcro wraps to hold the tubes to the frame but I haven't attached any yet and the tubes have stayed nicely positioned on the frames and I have around 10 x 1KG spools of PLA on it at the moment.
This works as a really smart way of storing PLA in a small office or studio, the frames are very sturdy and the tubes haven't bent under the strain either which is great.
I printed on my CR10S-PRO and it worked a treat, Not sure whether it would work as well if scaled down though.
2 x lengths of 16mm tube are required and can be bought in most DIY stores or on eBay.
The holes in the frames were designed to allow a tie wraps or Velcro wraps to hold the tubes to the frame but I haven't attached any yet and the tubes have stayed nicely positioned on the frames and I have around 10 x 1KG spools of PLA on it at the moment.
This works as a really smart way of storing PLA in a small office or studio, the frames are very sturdy and the tubes haven't bent under the strain either which is great.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
