Thingiverse
Filament Spool Rack
von merlinds
21
Downloads
12
Likes
0
Makes
Got tired of having my spools in a regular holder, and having to swap them all the time.
The idea is that you can make a rack as long as you want, provided that you have enough 8mm smooth rod.
What you will need:
At least two supports (you need to print each half and then glue them together to have 1 support)
4 bearings for each filament spool that you want to hold.
Enough clips to hold all the bearings in place.
enough 8mm smooth rod, just measure your spools, add some wiggle room and then multiply for the number of spools you want to hold.
screws appropiate for the surface you want to mount it in.
In the pictures you will se an actual bearing, that is from an older version that proved to be useless so I remove it.
The idea is that you can make a rack as long as you want, provided that you have enough 8mm smooth rod.
What you will need:
At least two supports (you need to print each half and then glue them together to have 1 support)
4 bearings for each filament spool that you want to hold.
Enough clips to hold all the bearings in place.
enough 8mm smooth rod, just measure your spools, add some wiggle room and then multiply for the number of spools you want to hold.
screws appropiate for the surface you want to mount it in.
In the pictures you will se an actual bearing, that is from an older version that proved to be useless so I remove it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
