Thingiverse
Filament Spool Wall Holder
door fishku
38
Downloads
38
Likes
0
Makes
This simple spool holder requires a bar or pipe that goes inbetween the two printed parts.
The dimension of the gap for the bar/pipe is 30mm in diameter. I use an aluminium pipe with 25mm diameter with it. Scale the part up if you plan to use it with a larger bar/pipe. I recommend a metal pipe to reduce friction on the spools.
I use a pipe of 500mm length, which will fit about 4-6 1kg spools comfortably. I haven't tested longer pipes / more weight. Please be careful when putting lots of load on the parts!
The part corresponds to the right wall holder part.
Mirror & flip by 180 degrees in your slicer to get the left one.
The screw holes are 5mm in diameter. I use slightly thinner, but fairly long, screws with it.
The part is 190x210x40mm in size.
The dimension of the gap for the bar/pipe is 30mm in diameter. I use an aluminium pipe with 25mm diameter with it. Scale the part up if you plan to use it with a larger bar/pipe. I recommend a metal pipe to reduce friction on the spools.
I use a pipe of 500mm length, which will fit about 4-6 1kg spools comfortably. I haven't tested longer pipes / more weight. Please be careful when putting lots of load on the parts!
The part corresponds to the right wall holder part.
Mirror & flip by 180 degrees in your slicer to get the left one.
The screw holes are 5mm in diameter. I use slightly thinner, but fairly long, screws with it.
The part is 190x210x40mm in size.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
