Filament stand

When looking for a stand for filament spools, I couldn't find something that wouldn't absorb a lot of filament.I designed tees and a base to connect the wooden poles.Thanks to this design, the height of the spools can be freely adjusted.In my project, the legs are made of a 19 mm wooden shaft and the crossbars are 15 mm.The transverse sections of the shaft are 8 cm long, which ensures that the filament spool stays in place.I put up vertical posts so that I could add another floor. I think that 3 floors of filament is a safe height, without additional attachment to the wall.The holes allow you to assemble the stand using screws.The use of wooden sticks allows you to adjust the ends with sandpaper so that they fit into the shapes.Print profile for PLA.Layer height 0.24 mm.Necessary supports (I used a tree).