Thingiverse
Filament Stand
von Mauritsio
8
Downloads
4
Likes
0
Makes
This is a lavish looking filament spool holder for up to two rolls of filament.
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT: PLA is totally fine for this, no need start a hassel with ABS oder PETG etc.
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT: PLA is totally fine for this, no need start a hassel with ABS oder PETG etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
