Thingiverse
Filament Stand
por mindcode
268
Descargas
245
Likes
2
Makes
Filament Stand - V1
Its adaptable to every filament spool width. Just adjust the both stands on the rail.
The parts are very narrow dimensioned, it may require force to put everything together.This is intented in order to provide a good behaivor and cohesion, so be careful. Don't hesitate to raise the infill more above 25% because of that.
You are going to need bearings: 608 ZZ
Inner diameter: 8 mm
Outer diameter: 22 mm
Width: 7 mm
Its adaptable to every filament spool width. Just adjust the both stands on the rail.
The parts are very narrow dimensioned, it may require force to put everything together.This is intented in order to provide a good behaivor and cohesion, so be careful. Don't hesitate to raise the infill more above 25% because of that.
You are going to need bearings: 608 ZZ
Inner diameter: 8 mm
Outer diameter: 22 mm
Width: 7 mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
