Filament Stand

**sorry the pictures are squashed flat. Thingiverse is doing that for some reason.**

I'll start with a bold claim: my 3d prints are better because of this filament spool holder. The crashes I was getting with the existing holder weren't just wasting time and money, they were a symptom of more or less continual problems with tension from the existing spool. That tension, when it wasn't outright crashing the spool and/or printer, was sometimes providing enough resistance to the print head to shift the x-axis half a mm in the middle of a print, or to just give fuzzy edges to prints that should have been smoother.

A filament spool holder that meets my needs. Axle comes in two pieces and should just friction fit together. If not, glue will do the job and it should fit through spools anyway. The tolerances on your printer, your filament shrinkage, etc. can all have an effect on whether this is a slip fit or a friction fit. On our prusa, they're not a friction fit. You can try the vers