Filament stand

This is a Filament stand so that you can conveniently hold your spools with easier access. It has a strong triangular design with honeycomb pattern in between the triangle.
There is also a small hole in the legs to guide your filament and stop unwinding.

To make sure this stand is right for you spool check these specifications fit:
Minimum spool inner diameter: 48mm
Maximum spool outer diameter: 140mm

Recommended Print settings:
4 walls
Gyroid pattern infill at 15%
Orientation flat on its back for faster printing
Support on (Tree recommended)

See all my models at:
https://www.printables.com/@Print3d_2522000