Thingiverse
Filament storage system
di DarthBane
8
Download
10
Likes
0
Makes
A thing to store your filament spools in a closet, using the closet rod that is normally in the closet.
This allows to simply put the filament spools on 2 rods, so they could be in a plastic bag, or not, it doesn't matter, it's more or less just a "shelf" created by 2 wooden rods, so the spools can't roll.
You'll need 2x 1" diameter wooden rod (from home hardware store), or 7/8" diameter.
You also need to print 2 of each brackets, and if your closet is wide and you want to use the entire length you might want to print 1 extra to put in the middle for support.
It comes in 2 pieces as you can see, and they dovetail into each other (it did not fit in my printer, which is 220mm x 220mm bed, but these 2 pieces do fit in that size, 1 at a time).
This allows to simply put the filament spools on 2 rods, so they could be in a plastic bag, or not, it doesn't matter, it's more or less just a "shelf" created by 2 wooden rods, so the spools can't roll.
You'll need 2x 1" diameter wooden rod (from home hardware store), or 7/8" diameter.
You also need to print 2 of each brackets, and if your closet is wide and you want to use the entire length you might want to print 1 extra to put in the middle for support.
It comes in 2 pieces as you can see, and they dovetail into each other (it did not fit in my printer, which is 220mm x 220mm bed, but these 2 pieces do fit in that size, 1 at a time).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
