Thingiverse
Filament Support
von RatSalada
0
Downloads
13
Likes
0
Makes
Filament Support for aluminium profile printers (Ender 3, Cr-10 ,etc ...)
Made extra strong so it can be printed even with weaker filaments
You will need two M4x10 screw and two M4 T-nut
Print recommendations:
>15% infill (grid or honeycomb
6 top layer 6 bottom layer and 6 walls
high nozzle temperature
The screw and nut may be difficult to print and fit. To make it easy to fit i would recomend to use a -0.06 ~ 0.1 horizontal expansion and/or turn on "make overhangs printable"
Made extra strong so it can be printed even with weaker filaments
You will need two M4x10 screw and two M4 T-nut
Print recommendations:
>15% infill (grid or honeycomb
6 top layer 6 bottom layer and 6 walls
high nozzle temperature
The screw and nut may be difficult to print and fit. To make it easy to fit i would recomend to use a -0.06 ~ 0.1 horizontal expansion and/or turn on "make overhangs printable"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
