Thingiverse
FilamentBoxTable
door JoeS2021
29
Downloads
15
Likes
0
Makes
I purchased a dry box from Creality to protect it from dust and moisture.
The filament feed of the Ender6 is exactly above the power cord and power switch. For this I printed a table that is attached to the rear profile with 2 screws of the acrylic glass.
This table is suitable for the Creality Dry Box (100x220mm).
The table should preferably be printed in PETG because of the strength.
It can be printed on edge on the Ender6. The top edge is constructed with phase and does not need support.
Because I installed a Directextruder, I made a spacer for the Bowden connector.
The filament feed of the Ender6 is exactly above the power cord and power switch. For this I printed a table that is attached to the rear profile with 2 screws of the acrylic glass.
This table is suitable for the Creality Dry Box (100x220mm).
The table should preferably be printed in PETG because of the strength.
It can be printed on edge on the Ender6. The top edge is constructed with phase and does not need support.
Because I installed a Directextruder, I made a spacer for the Bowden connector.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!