Fillament Storage Top mounted

I couldnt find any fillament storage solutions that would fit my needs as there were none that were top mounted so i created this and figured why not upload it so maybe someone else could use the solution It uses 22m dowels which i made to make sure that it was a tight fit. I used timber dowels in mine, originally i had just the external ones but then there was a little spreadding over about 1800mm so i created a centre bracket for support. which can be used to extend dowels if lapped in the centre braket. i believe an attachment to connect the two so they dont spread would also work reasonably well Note: if it matters to you you can adjust the sides so you can position the build plate side to the back. I used PLA and have no issues, however if you want to use PETG you're more than welcome to.Each buildplate can fit 4x external brackets, though if you have adhesion issues i found that because it's so close to the aux fan, you may need to turn it off (I have adjusted the file to