Thingiverse
Fillenium Malcon (repaired and complete models)
von DrLex
2.2k
Downloads
1.6k
Likes
23
Makes
This is aaskedall's original “[space ship thing](http://www.thingiverse.com/thing:919475),” with a few improvements.
First, the original models had **non-manifold errors** that caused problems in some slicer programs (like Slic3r). I spent quite a bit of time getting rid of these errors manually. While doing this, I also straightened out the landing gear because there was an offset between the left and right sides. And, the center of the original satellite dish is no longer free-floating. In other words, unlike the originals, these models should cause no trouble in slicer programs, and there should not be any unexpected flaws in the result. Even in programs that have no problem with the original models, the output might look nicer when printed in large sizes.
Next, I **completed the missing rear end,** something many people have been asking for a long time. This also was a manual process, extrapolating the existing structures as much as I could and guessing the rest. I ensured th
First, the original models had **non-manifold errors** that caused problems in some slicer programs (like Slic3r). I spent quite a bit of time getting rid of these errors manually. While doing this, I also straightened out the landing gear because there was an offset between the left and right sides. And, the center of the original satellite dish is no longer free-floating. In other words, unlike the originals, these models should cause no trouble in slicer programs, and there should not be any unexpected flaws in the result. Even in programs that have no problem with the original models, the output might look nicer when printed in large sizes.
Next, I **completed the missing rear end,** something many people have been asking for a long time. This also was a manual process, extrapolating the existing structures as much as I could and guessing the rest. I ensured th
DrLex veröffentlicht auch auf
29 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![[Remix] Millenium Falcon Mold Maker (Manifold Fix)](/imgproxy.php?url=https%3A%2F%2Fresize.thingiverse.com%2F%3Furl%3Dhttps%3A%2F%2Fcdn.thingiverse.com%2Fassets%2F7d%2Fa4%2F20%2Ff7%2F7a%2FIMG_4595.jpg%26w%3D1024%26h%3D1024%26fit%3Dcontain%26cbg%3Dwhite&w=400&h=300)