Thingiverse
Filter adapter for mini cyclone
von LVK73_DK
43
Downloads
21
Likes
0
Makes
I made this filter holder design to fit the mini cyclone so that i dont have to clean the filter in the vacuumcleaner that often.
The shells are designed to contain two frames to control the filter material. The filter material must not be too thick, to prevent big reduction in suction.
The shells shall be printed with supports. The supports can be blocked in the top of the shell with the square adapter, but both need supports at the build plate.
The shells are designed to contain two frames to control the filter material. The filter material must not be too thick, to prevent big reduction in suction.
The shells shall be printed with supports. The supports can be blocked in the top of the shell with the square adapter, but both need supports at the build plate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
